Painting In the operation of cranes lifting equipment, especially one that is outdoors, there is corrosion of metal. Under the influence of rainfall, industrial gases and air paint layer begins to break down. The result is that metallic structures are not protected from the environment. Metal starts to break down. Metal thickness is reduced, leading to a reduction strength characteristics.

It primarily affects the safety equipment operated as well as staff that is directly related to this product. Operation of this equipment is prohibited by the rules of PB 10-382-00. Our company performs the full range of works on paint lifting technique: – cleanup of old paint and rust – degrease the surface – coating primer – Paint Application. All work is done experienced staff our company with high quality materials manufacturers painting metal painting metal – work that requires professional expertise and knowledge. Painting Metal is not possible without high-quality metal protection against corrosion.

Stained metal is carried out only after careful preparation surface to a mechanical or chemical method. Painting metal is performed after cleaning them manually, mechanically or abrasive manner. Coloring metal and metal preparation for painting held to improve the adhesion (bond) paint to the surface metal, to protect and prevent corrosion, extend the service life of steel structures. Paint required for all products made of metal. Painting a metal requires the following work: 1. Removing old paint coverage, if available. 2. Cleavage and trimming of rust. 3. Complete cleaning of metal surfaces from dirt, dust and debris. Contamination is always present in all objects and structures, and, if ignored, will be ground or enamel sliding down a metal film or give a heterogeneous, leading to what color of metal will be implemented poorly. 4. Polishing the surface, removing shirohovatostey, scratches. Paint and coating of metal performed only on a flat, defect-free surface. 5. Degrease the surface, removing oils, greases, grease alkaline, acidic, organic or emulsion cleaners. 6. Drying the surface for prevent corrosion and improve adhesion to the surface of the paint. 7. Priming the surface of special structures in two or more layers (as instructed), waiting to dry each layer for improve adhesion. Necessary to shorten the time between cleaning of metal, priming and painting, not to carry out preparatory work again, because the metal surface can again dirty, dusty, or otsyret. Painting of metal whose price is indicated in the price, it should be immediately after preparation. The cost of painting steel structures depends on the area substrate, the complexity of the design. The final price of painting the metal will be given after examination by our specialist metalwork